dbroqua/kobol-wiki
1
0
Fork 0
Code Issues Pull Requests Projects Releases Wiki Activity

Add quick instructions to H64 button page for Recovery button

This commit is contained in:
Gauthier Provost 2020-10-20 13:27:31 +08:00
parent ec998f2742
commit 3b8e41febe
1 changed files with 12 additions and 1 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

13
docs/helios64/button.md
View File

@ -21,6 +21,17 @@ Helios64 board provides a RESET push button (SW3) to hard reset the system.
Helios64 board provides a RECOVERY push button (SW2) to allow user to easily flash over USB the on-board eMMC storage. This can be useful if you want to do a fresh install or if you want to repair a system that doesn't boot anymore.
User can enter recovery mode by pressing this button during boot up (bootloader stage). U-Boot will read the button state and switch the USB type-C port into USB Mass Storage device to expose eMMC flash as storage device. User can then use flash tools to write new OS image into eMMC flash.
User can enter recovery mode by pressing this button during boot up (bootloader stage). U-Boot will read the button state and switch the USB type-C port into USB Mass Storage device to expose eMMC flash as storage device (UMS mode).
!!! note
Recovery mode is only supported since Armbian version 20.08.13. You need to have U-Boot installed either on microSD card or on eMMC. Refer to fresh install [section](/helios64/install/preliminary/#install-options) if you haven't setup your system yet.
**Quick Instructions :**
1. Press and hold Recovery Button during power-up until System Status LED blinks 1 time. System should enter UMS mode and your computer should have detected a new storage device called _Linux UMS disk 0_.
2. User can then use flash tools to write new OS image into eMMC flash. Refer to this [section](/helios64/install/emmc/#step-5-writing-an-os-image-to-internal-emmc).
User can also enter into *maskrom* mode in order to use some of the Rockchip programming tools (e.g [rkdeveloptool](https://github.com/rockchip-linux/rkdeveloptool)). For this, you will need first to enable [Jumper 13](/helios64/jumper/#usb-consolerecovery-mode-p13). To enter *markrom* mode, press and hold Recovery Button during power-up until System Status LED blinks 2 times.
Under Linux, this button behaves as user button and when pressed will emit **BTN_0** keycode (refer to [Linux Input Codes](https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/plain/include/uapi/linux/input-event-codes.h)). Therefore this button can also be used to trigger other actions than recovery.