9.3 KiB
USB on RK3399
There are two types of USB controller available on RK3399. Each type has two controller so total USB controllers is 4.
Generic EHCI USB 2.0 Controller
There are two controller of this type. This controller is Host only controller that is compatible with USB 2.0 and backward compatible with USB 1.1. Supported speed:
-
High Speed (480 Mbps)
-
Full Speed (12 Mbps)
-
Low Speed (1.5 Mbps)
Synopsys DesignWare USB 3.0 Dual-Role Device Controller
There are two controller of this type. This controller support On-The-Go /Dual Role which mean it can be configured as Host and also Device. Supported speed:
-
Super Speed (5 Gbps)
-
High Speed (480 Mbps)
-
Full Speed (12 Mbps)
-
Low Speed (1.5 Mbps)
The controller is connected to Rockchip Type-C PHY.
USB on Helios64
One of EHCI Controller is connected to M.2 socket.
The first Synopsys DesignWare USB 3.0 Dual-Role Device Controller is connected to USB Type-C connector and configured as OTG with help of FUSB302.
The second Synopsys DesignWare USB 3.0 Dual-Role Device Controller is connected to USB Hub 3.1 Gen 1 and configured as Host only.
Power Budget
Each of external USB port is protected by Power Distribution switch with following current limit.
| Port | Voltage | Maximum Current | Remarks |
|---|---|---|---|
| USB 3.0 Upper Back Panel | 5V | 900 mA | |
| USB 3.0 Lower Back Panel | 5V | 900 mA | |
| USB 3.0 Front Panel | 5V | 900 mA | |
| Type-C | 5V | 1200 mA | PDO source only |
USB Type-C Functionality on Helios64
To simplify the cabling, Helios64 is designed to have
Serial Console
Serial Console of Helios64 is connected to FT232 USB Serial converter and the USB 2.0 signal of the FT232 is connected to USB 2.0 signals of USB Type-C Port. Refer to JUMPER PAGE
DisplayPort Alternate Mode
Using USB Type-C to DisplayPort cable or USB Type-C to HDMI dongle, Helios64 can be connected to monitor to display Linux Desktop or other GUI application.
*** Put USB Type-C to DisplayPort cable photo here ***
*** Put USB Type-C to HDMI dongle photo here ***
!!! note DisplayPort Alternate Mode is NOT supported on U-Boot.
USB Host
Using OTG cable such as,
Helios64 can act as USB host and can be connected to various USB device.
USB Device
Helios64 can be used as Direct Attached Storage (DAS) with proper configuration and kernel module. Refer to Helios64 as Direct Attached Storage (DAS) device
Helios64 can also used as "USB eMMC reader/writer" for OS recovery purpose. Refer to USB OTG Port (USB Type-C)
USB under U-Boot
USB Host Port
USB Host support in U-Boot is quite minimal, it only support USB storage and USB ethernet.
USB OTG Port (USB Type-C)
USB Type C port is configured as USB device mode as USB Mass Storage connected to eMMC. This function can be activated by pressing Recovery Button. This is to serve as a way to (re)install OS to eMMC.
USB under Linux
USB Bus Mapping
| USB Controller | Bus number | Remarks |
|---|---|---|
| EHCI Host0 | 0 | |
| EHCI Host1 | 1 | |
| DWC3 Typec0 USB 3.0 | 2 | |
| DWC3 Typec0 USB 2.0 | 3 | |
| DWC3 Typec1 USB 3.0 | 4 | |
| DWC3 Typec1 USB 2.0 | 5 |
----- TBC ------
Helios64 as Direct Attached Storage (DAS) device
Helios64 can be used as Direct Attached Storage (DAS) device with help of Linux USB Gadget kernel module.
The kernel moodule only export the underlying block device NOT the filesystem layer. Therefore if the block device is formatted with filesystem unique to Linux, the exported disk may not readable by computer that has Helios64 connected to.
For example, the block device is formatted with EXT4 filesystem and Helios64 connected to Windows PC as DAS, the Windows PC will not be able to read the disk content unless 3rd party software/driver installed.
!!! warning Do NOT access Helios64 simultanouesly as DAS and NAS, as the filesystem is not managed by system and can lead to data corruption.
Individual Disk Exported as Separate Disk
----- more info soon -----
modprobe g_mass_storage file=/dev/sda,/dev/sdb,/dev/sdc,/dev/sdd,/dev/sde iSerialNumber=1234567890 iManufacturer="Kobol Innovations" iProduct=Helios64
----- *** Put Windows Explorer & Disk management screenshot here *** -----
Helios64 connected to PC running Linux
USB device visualization using USBview
USB tree using lsusb
$ sudo lsusb -s 2:7 -v
Bus 002 Device 007: ID 0525:a4a5 Netchip Technology, Inc. Pocketbook Pro 903
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 3.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 9
idVendor 0x0525 Netchip Technology, Inc.
idProduct 0xa4a5 Pocketbook Pro 903
bcdDevice 4.04
iManufacturer 3 Kobol Innovations
iProduct 4 Helios64
iSerial 5 1234567890
bNumConfigurations 1
OTG Descriptor:
bLength 3
bDescriptorType 9
bmAttributes 0x03
SRP (Session Request Protocol)
HNP (Host Negotiation Protocol)
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 47
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0xe0
Self Powered
Remote Wakeup
MaxPower 126mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 8 Mass Storage
bInterfaceSubClass 6 SCSI
bInterfaceProtocol 80 Bulk-Only
iInterface 1 Mass Storage
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0400 1x 1024 bytes
bInterval 0
bMaxBurst 15
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x01 EP 1 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0400 1x 1024 bytes
bInterval 0
bMaxBurst 15
Binary Object Store Descriptor:
bLength 5
bDescriptorType 15
wTotalLength 22
bNumDeviceCaps 2
USB 2.0 Extension Device Capability:
bLength 7
bDescriptorType 16
bDevCapabilityType 2
bmAttributes 0x00000006
Link Power Management (LPM) Supported
SuperSpeed USB Device Capability:
bLength 10
bDescriptorType 16
bDevCapabilityType 3
bmAttributes 0x00
wSpeedsSupported 0x000f
Device can operate at Low Speed (1Mbps)
Device can operate at Full Speed (12Mbps)
Device can operate at High Speed (480Mbps)
Device can operate at SuperSpeed (5Gbps)
bFunctionalitySupport 1
Lowest fully-functional device speed is Full Speed (12Mbps)
bU1DevExitLat 1 micro seconds
bU2DevExitLat 500 micro seconds
Device Status: 0x0000
(Bus Powered)
xfce file manager (thunar)
lsblk output:
$ lsblk
NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT
sdc 8:32 0 111,8G 0 disk
└─sdc1 8:33 0 111,8G 0 part
sdd 8:48 0 111,8G 0 disk
└─sdd1 8:49 0 111,8G 0 part
sde 8:64 0 111,8G 0 disk
└─sde1 8:65 0 111,8G 0 part
sdf 8:80 0 111,8G 0 disk
└─sdf1 8:81 0 111,8G 0 part
sdg 8:96 0 111,8G 0 disk
└─sdg1 8:97 0 111,8G 0 part
$ lsblk -S
NAME HCTL TYPE VENDOR MODEL REV TRAN
sda 0:0:0:0 disk ATA WDC WDS240G2G0B- 0000 sata
sdb 1:0:0:0 disk ATA TOSHIBA MQ04ABF1 0J sata
sdc 2:0:0:0 disk Linux File-Stor Gadget 0404 usb
sdd 2:0:0:1 disk Linux File-Stor Gadget 0404 usb
sde 2:0:0:2 disk Linux File-Stor Gadget 0404 usb
sdf 2:0:0:3 disk Linux File-Stor Gadget 0404 usb
sdg 2:0:0:4 disk Linux File-Stor Gadget 0404 usb
RAID device exported as One Disk
----- more info soon -----
modprobe g_mass_storage file=/dev/md/md-raid6
----- *** Put Windows Explorer & Disk management screenshot here *** -----
----- *** Put lsusb & lsblk here *** -----
Benchmark
----- more info soon -----
References
[1] https://www.kernel.org/doc/html/v5.4/usb/mass-storage.html